Resumen

RICO-PEREZ, L.; ZALAPA-GARIBAY, M. A.; MOLINA-SALAZAR, J.  y  CLEMENTE-MIRAFUENTES, C. M.. Statistical analysis and mathematical modeling of cutting parameters in the turning process of 1018 steel material. J. appl. res. technol [online]. 2025, vol.23, n.1, pp.62-68.  Epub 22-Ago-2025. ISSN 2448-6736.  https://doi.org/10.22201/icat.24486736e.2025.23.1.2541.

This paper presents an analysis and mathematical modeling of the cutting parameters in the turning process of 1018 steel material. For this analysis, an experiment was designed using 40 specimens of 1" diameter by 6" long. In this experiment, the control parameters were cutting speed in revolutions per minute (rpm), feed rate in inches per minute (inches/minute) and depth of cut in inches (inches), while the response variable is surface roughness in micro inches (μinches). The results show that the feed rate, cutting speed and the interaction between feed rate and cutting speed affect the surface roughness of the workpiece. Finally, with the RStudio software, a mathematical model was obtained with an R2 equal to 0.99, a value very close to previous experimental works and, in addition, a good predictor of surface roughness.

Palabras llave : Statistical analysis; turning process; mathematical modeling; cutting parameters.

        · texto en Inglés     · Inglés ( pdf )