Servicios Personalizados
Revista
Articulo
Indicadores
- Citado por SciELO
- Accesos
Links relacionados
- Similares en SciELO
Compartir
Revista mexicana de física
versión impresa ISSN 0035-001X
Rev. mex. fis. vol.54 no.1 México feb. 2008
Investigación
Effect of CaO on the microstructure and nonohmic properties of (Co,Sb)doped SnO2 varistors
J.A. AguilarMartíneza,b,*, A. DuránRégulesc, A.B. Glotd, M.B. Hernándeze, M.I. PechCanulff, and J. CastilloTorresg
aCentro de Investigación en Materiales Avanzados, S.C. (CIMAV), Miguel de Cervantes 120, Complejo Industrial Chihuahua, 31109 Chihuahua, Chihuahua, México.
bInstituto de Minería,
c Dept. de Ingeniería Industrial,
d Div. de Estudios de Postgrado,
eInstituto de Diseño,
gInstituto de Física y Matemáticas, Universidad Tecnológica de la Mixteca, Carr. Acatlima Km. 2.5, Huajuapan de León, Oaxaca, México 69000.
fCinvestav Saltillo, Carr. SaltilloMonterrey Km. 13, Saltillo, Coah., México, 25900.
* Corresponding author:
Formerly at Instituto de Minería,
from November 2007,
with Centro de Investigación en Materiales Avanzados,
Tel: + 52 (614) 4391188,
email: josue.aguilar@cimav.edu.mx
Recibido el 29 de junio de 2007
Aceptado el 23 de octubre de 2007
Abstract
The effect of CaO through additions of CaCO3 on the physical characteristics, microstructure, and currentvoltage properties of (CoSb)doped SnO2 varistors was investigated. SnO2Co3O4Sb2O5 ceramics with additions of 0.1, 0.5 and 1 mol % CaO were sintered at 1450°C under oxidizing atmosphere and characterized by scanning electron microscopy (SEM), energy dispersive Xray spectroscopy (EDX), and Xray diffraction (XRD). Results show that, at low and intermediate CaO levels, density is not significantly influenced, whilst at the highest level, density decreases substantially. The nonlinear coefficient and the breakdown voltage behave similarly in one sense because both present a maximum, and because at the highest CaO level, both response variables show the lowest values. The nonlinear coefficient presents a maximum of 12.9 at 0.1 mol % CaO, while the same maximum for the breakdown voltage occurs at 0.5 mol % CaO. At 1 mol % CaO, the breakdown voltage is 288 Vcm1.
Keywords: Varistors; breakdown voltage; nonlinearity.
Resumen
Se investigó el efecto del CaO a través de adiciones de CaCO3 sobre las características físicas, la microestructura y las propiedades corrientevoltaje de varistores de SnO2 dopados con Co y Sb. Los cerámicos SnO2Co3O4Sb2O5 dopados con 0.1, 0.5 y 1% molar de CaO fueron sinterizados a 1450 °C bajo condiciones oxidantes y caracterizados por microscopía electrónica de barrido (MEB), espectroscopía por energía dispersiva de rayos X (EDX) y por difracción de rayos X (DRX). Los resultados muestran que, a niveles bajo e intermedio de CaO, la densidad no se ve afectada significativamente mientras que al nivel más alto, la densidad disminuye sustancialmente. El coeficiente de no linealidad y el voltaje de ruptura se comportan en un sentido de manera similar, porque ambos presentan un máximo y porque al nivel más alto de CaO ambos presentan los valores más bajos. El coeficiente de no linealidad presenta un máximo de 12.9 a 0.1% molar de CaO, mientras que el máximo correspondiente para el voltaje de ruptura ocurre a 0.5% molar de CaO. A 1% molar de CaO, el voltaje de ruptura es de 288 V cm1.
Descriptores: Varistores; voltaje de ruptura; no linealidad.
PACS: 61.72.Ji; 61.72Mm; 84.32.Ff; 84.37.+q
DESCARGAR ARTÍCULO EN FORMATO PDF
Acknowledgements
This study was conducted within the framework of project SEP2003C0242821, CONACYT, Mexico. Authors gratefully acknowledge Mr. Miguel A. Aguilar González' assistance in the microstructure characterization by SEM.
References
1. P.R. Bueno et al., Cerámica 46 (2000) 124. [ Links ]
2. L. Levinson and H. Philipp, IEEE Trans. Parts, Hybrids, and Packaging 13 (1977) 338. [ Links ]
3. T.K. Gupta, J. Am. Ceram. Soc. 73 (1990) 1817. [ Links ]
4. D.R. Clarke, J. Am. Ceram. Soc. 82 (1999) 485. [ Links ]
5. M. Peiteado, Bol. Soc. Esp. Ceram. V. 44 (2005) 77. [ Links ]
6. M. Matsuoka, Jpn. J. Appl. Phys. 10 (1971) 736. [ Links ]
7. L. Kong, L. Zhang, and X. Yao, Mater. Lett. 32 (1997) 5. [ Links ]
8. J. Li, S. Li, F. Liu, M.A. Alim, and G. Chen, J. Mater. Sci.: Mater. Electr. 14 (2003) 483. [ Links ]
9. A.B. Glot and A.P Zlobin, Inorg Mater. 25 (1989) 274. [ Links ]
10. Z.M. Jarzebski and J.P Marton, J. Electrochem. Soc. 123 (1976) 199C. [ Links ]
11. I.T. Weber, E.R. Leite, E. Longo, and J.A. Varela, Cerámica 46 (2000) 156. [ Links ]
12. P.S. More Mater. Lett. 58 (2003) 205. [ Links ]
13. S.A. Pianaro, P.R. Bueno, E. Longo, and J.A. Varela, J. Mater. Sci. Lett. 14 (1995) 692. [ Links ]
14. J.A. Cerri, E.R. Leite, D. Gouvea, E. Longo, and J.A. Varela, J. Am. Ceram. Soc. 79 (1996) 79. [ Links ]
15. M.R. CássiaSantos et al, Mater. Chem. Phys. 90 (2005) 1. [ Links ]
16. R.F. Speyer, Thermal Analysis of Materials (Marcel Dekker Inc., New York, 1994). [ Links ]
17. K.H. Stern, High temperature properties and thermal decomposition of inorganic salts with oxyanions (CRC Press, New York, 2000). [ Links ]