Resumo

MONGE-GAPPER, Juan Gabriel  e  SERRANO-PACHECO, Alberto. An implementation of the SPH method and its application to two-dimensional dam break cases. Ing. invest. y tecnol. [online]. 2023, vol.24, n.1, e1886.  Epub 25-Maio-2023. ISSN 2594-0732.  https://doi.org/10.22201/fi.25940732e.2023.24.1.005.

A basic implementation of the weakly compressible smoothed particle hydrodynamics (W-SPH) method is used to model the open surface flow phenomena of three different cases of hydraulic problems. They were all two-dimensional approximations of known hydraulics problems: dam break over dry bed and dam break over wet bed with shallow and deep variants. For all models, the results were compared quantitatively with data from waterfront profiles from previously published experiments. A qualitative approach was used to assess the general profile shape comparing the numerical hydraulic profile results with published photographs of all setups shown. The numerical model converged to a stable solution with relatively low-resolution setups (2000 to 20000 particles) and a good correlation was found with the experimental and numerical references, even without the application of correction algorithms. Numerical oscillations in the density field did produce small artificial waves and vortices, but did not interfere with the behavior of the bulk of the fluid except for some delay in the speed of surface waves. The choice of developing an entirely original, self-contained source code, although very insightful, does mean that the neighboring particle search algorithm implemented considerably increases the associated computational cost. However, using this insight along with the basis of the comparison with experimental results, optimization priorities for the source code were found and some guidelines to choose fluid resolution and boundary density can be applied for future cases where the flow phenomena are similar to those studied. Also, the experience of writing the SPH source code that was used to solve the numerical models, shows the path for future developments on fluid flow modeling using this method.

Palavras-chave : Particle method; dam break; numerical model; wet bed; source code.

        · resumo em Espanhol     · texto em Inglês     · Inglês ( pdf )