Servicios Personalizados
Revista
Articulo
Indicadores
- Citado por SciELO
- Accesos
Links relacionados
- Similares en SciELO
Compartir
Superficies y vacío
versión impresa ISSN 1665-3521
Resumen
MORO-FRIAS, D. et al. Diseño y simulación de un circuito de control automático de ganancia para sistemas sensores. Superf. vacío [online]. 2012, vol.25, n.1, pp.36-42. ISSN 1665-3521.
The role of an Automatic Gain Control (AGC) circuit is to provide relatively constant output amplitude regardless of the signal variations at its input. For this reason, AGC circuits reduce the required input dynamic range of subsequent conditioning circuits for resonant sensors, where information is frequency modulated. An AGC circuit in a 0.35µm and biased with VDD=3V is presented in this paper, to be used in sensor systems operating from DC to 100kHz. The Variable Gain Amplifier is based on a novel technique which uses a pre-distortion piecewise-linear block to exponentially vary the gain. The total harmonic distortion is lower than -54dB and the power consumption of the whole system is 12.4mW. The results were obtained by HSpice simulations.
Palabras llave : CMOS analog design; Automatic gain control; PWL predistortion.